Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterGate Repair in Reseda, CA
Gate access control in Reseda usually comes down to two things: a keypad or intercom that stopped reading in the Valley heat, or a gate that won’t stay closed because the 1994 Northridge earthquake’s epicenter left block-wall posts slightly out of true across this neighborhood. Most Reseda homes run 1950s-1970s wrought-iron swing gates mortared into CMU block pilasters, and when the gate binds or the latch won’t strike, the fix often starts at the post, not the electronics. Call (424) 258-8818 and we’ll tell you what’s actually wrong before anyone picks up a tool.
Why Reseda Homes Are Different
Reseda sits deep in the San Fernando Valley heat basin, where summer highs of 105-110°F are routine. That thermal load expands steel gate frames until they bind against block openings in the afternoon, then contract overnight. After forty or fifty summers, hinge welds fatigue and latch strikes drift out of alignment, which means a gate that closes fine at 8 a.m. can refuse to latch by 3 p.m.
The block walls themselves are the other half of the story. The Northridge earthquake was centered here in Reseda, and many concrete masonry pilasters still carry hairline cracks in the footings or anchor bolts that shifted during the shaking. We regularly find gates pulling away from posts that look fine from the street but are out of plumb by an inch or more once you put a level on them. Repairing the gate hardware without checking the post means redoing the job in a season.
Pool gate latch failures are also disproportionately common in Reseda because backyard pool density is high and the UV index destroys the spring tension in self-closing latch hardware within a season or two. That’s a California pool-barrier code issue, not just an inconvenience, and it shows up on a lot of our residential calls here.
Our Main Reseda Services
These are the three services Reseda homeowners call about most, and each one has its own page with full pricing and sub-job detail.
Gate Repair in Reseda
Most repair calls in Reseda involve swing gates on 50-70-year-old posts, where the hinge pockets in the block have rusted or the pintles have worn down. We check the post plumb first, then the hinge and latch geometry, because a gate that won’t close properly in this neighborhood is usually a post problem disguised as a hardware problem. The written price comes before any work starts. See Gate Repair in Reseda for full details.
Gate Installation in Reseda
New gates in Reseda almost always mean working around existing CMU block walls, which is fine when the posts are sound and a problem when they’re not. We measure the opening, check the post footings for earthquake damage, and quote the job with a written scope that includes exactly what gets replaced and what gets reused. See Gate Installation in Reseda for full details.
Gate Motor & Opener in Reseda
Heat is the main killer of gate motors in Reseda, and so are the voltage drops that come with older Valley wiring. We service nine automation brands and we’ll tell you whether the motor can be repaired or needs replacement before we quote anything. See Gate Motor & Opener in Reseda for full details.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
BeforeAfterGate Access Control in Reseda
Gate access control in Reseda usually means a keypad, intercom, or phone-entry system that needs to survive direct afternoon sun and 105°F heat while mounted on a block wall that may have shifted during the Northridge earthquake. Most of what we do here is repair and retrofit existing systems, not rip-and-replace, and we document every wiring change with photos before we leave. That’s the same commercial documentation habit Adrian Vance brought over from access-control work starting in 2014, and it’s the core of our Gate Access Control practice.
Keypad Entry
Signs you need it
The keypad works in the morning but stops responding by mid-afternoon, or certain digits refuse to register.
What it costs in Reseda
Keypad replacement in Reseda typically runs $220-$475 depending on whether we can reuse the existing wiring and mount.
How we do it
We test the keypad output at the board, check the wiring for heat damage, replace the unit, and photograph the new settings.
Phone Entry
Signs you need it
Callers can’t hear you through the speaker, or the gate won’t open when you press the entry key on your phone.
What it costs in Reseda
Phone entry system repair in Reseda typically runs $285-$650 depending on whether the cellular module or just the wiring needs work.
How we do it
We isolate the fault to the control board, the phone line, or the relay, replace only what’s failed, and log every setting change.
What Gate Access Control Costs in Reseda
| Item | Typical range in Reseda |
|---|---|
| Keypad replacement | $220-$475 |
| Phone entry module repair | $285-$650 |
| Access control board replacement | $400-$900 |
How fast can you get a gate access control tech out in Reseda?
Most access control calls in Reseda are same-day or next-morning, and a live person answers the phone 24/7. Call (424) 258-8818 and we’ll give you a written price before any work starts.
Will the new keypad work with my existing gate motor?
Usually yes. We service DoorKing, LiftMaster, Linear, and every other major brand, so we match the access control to the motor you already have rather than selling you a full replacement.
Gate Parts & Welding in Reseda
Gate parts and welding in Reseda is often about rust and fatigue: 50-70-year-old wrought-iron frames with cracked corner welds, hinge pockets that have rusted out inside the block, and posts that need to be re-set after decades of thermal cycling and one very bad earthquake. We do mobile welding and part replacement on site, and every job leaves a written record of the part number installed and photos of the finished work. That’s the standard behind our Gate Parts & Welding service.
Hinge Replacement
Signs you need it
The gate sags toward the latch side, scrapes the ground when it swings, or the hinge pins rattle when the gate moves.
What it costs in Reseda
Hinge replacement on a standard Reseda swing gate typically runs $180-$520 per hinge set depending on the steel thickness and whether the block pocket needs rebuilding.
How we do it
We cut or unbolt the old hinge, grind the pocket clean, weld or epoxy the new hinge into the block, and level the gate before we leave.
Post Replacement
Signs you need it
The post leans visibly, the gate pulls away from the top hinge, or you can see a hairline crack running through the block from the anchor bolt.
What it costs in Reseda
Post replacement in Reseda typically runs $650-$2,200 depending on whether the footing needs re-pouring and whether the old post has wire run through it.
How we do it
We brace the gate, saw-cut the old post at the footing, set a new post in epoxy and anchor bolts, and photograph every step.
What Gate Parts & Welding Costs in Reseda
| Item | Typical range in Reseda |
|---|---|
| Hinge replacement | $180-$520 per hinge set |
| Post replacement | $650-$2,200 |
| Custom welding repair | $150-$600 per section |
Can you weld a cracked gate frame without removing the gate?
In most Reseda cases, yes. We weld the crack in place, grind it smooth, and paint the repair, then photograph the finished weld. Call (424) 258-8818 for a written quote.
Are parts in stock, or do I have to wait for an order?
We keep the common hinge sizes, rollers, and latch hardware on the truck for Reseda swing gates. Anything exotic is usually here within two or three days, and the price is written before we order it.
Brands We Service in Reseda
We service DoorKing, LiftMaster, Mighty Mule, and Elite openers, along with five other major automation brands. We keep common boards, remotes, and safety-edge parts stocked locally for Reseda homes, so most repairs don’t wait on a shipment. See our brands for the full list.
Pricing for Gate Repair in Reseda, CA
| Service | Typical range in Reseda |
|---|---|
| Keypad entry replacement | $220-$475 |
| Phone entry repair | $285-$650 |
| Access control board replacement | $400-$900 |
| Hinge replacement | $180-$520 per hinge set |
| Post replacement | $650-$2,200 |
| Custom welding repair | $150-$600 per section |
Prices in Reseda push upward when the 1994 earthquake left a post footing cracked or the block pocket has rusted through, because the repair stops being a hardware swap and starts being structural work. Everything is quoted in writing before we begin, so there’s no surprise invoice at the end.
Neighborhoods We Serve in Reseda
We work throughout Reseda, from the blocks around Reseda Boulevard and Sherman Way to the Lake Balboa edge and the streets north of Victory. Most calls get a same-day or next-morning response depending on the job.
- Reseda Ranch
- North Reseda
- Lake Balboa edge
- Reseda south of the 101
- West Reseda near Tampa
Service Area - Cities Near Reseda
We also serve the surrounding West Valley communities on a regular schedule. If you’re in Tarzana, CA, Northridge, CA, Encino, CA, or Canoga Park, CA, a live person answers the phone 24/7 and a tech can usually reach you the same day.
Serving Reseda, CA - Our Local Coverage Area
We’re based in the Reseda area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About Gate Repair in Reseda
For repair work, almost never. If the gate is being replaced and the posts are being reset with new footings, Los Angeles building code may require a permit depending on height and location, and we’ll tell you before we quote the job.
Most Reseda calls get same-day service when you call before early afternoon, and a live person answers at (424) 258-8818 at any hour. We’ll give you a written price before the tech starts working.
Some Reseda blocks and gated communities have HOA restrictions on gate color, height, and style. We work to the HOA spec when one exists, and we document that in the written scope so there’s no violation notice later.
What happens when you call
- 1A real person answersNo phone trees - talk to a local gate repair pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you - the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Reseda Customers Say
"Our gate was hit by a delivery truck. They came out, documented the damage properly for the insurer, and the claim went through without an argument."
- Camille R."Gate had been dragging for a year. They photographed the bent hinge post, explained why the operator kept faulting, and gave me a fixed price to correct both."
- Terrence B."Honest about what did not need doing. Told me the operator had years left and only the control board needed replacing."
- Douglas N.